Changing Parameter Settings; Changing Parameter Settings Using Card-Edge Controls - Imagine communications Selenio 6800 Installation And Operation Manual

Chapter 3: Operation

Changing Parameter Settings

Changing Parameter Settings using Card-Edge Controls

36
You can change parameter settings at the card edge for
HMX6800+BC8 modules; or you can change the parameter settings,
and view read-only parameters, and view alarms and adjust alarm
settings using CCS software. See the following topics for more
information:
• "Changing Parameter Settings using Card-Edge Controls" on
page 36
• "Changing Parameter Settings using CCS Software" on page 49
Follow these steps to change the HMX6800+BC8 parameter settings:
1. Rotate the hex switch (mode select rotary switch) to "0."
2. Once the hex switch is set to "0," toggle the navigation switch up or
down to select a bank.
View the two control LEDs next to the navigation toggle switch to
see which bank is currently selected. (See
See "Setting HMX6800+BC8 Control Parameters" on page 38
view the various banks, hex switch positions, and corresponding
parameter options and values.
Table 3-7. Selected Bank as Indicated by Control LEDs
LED 3 LED 2
Off Off
Off Off
Off Off
Off Off
Off On
Off On
Off On
Off On
On Off
On Off
LED 1 LED 0
Off Off
Off On
On Off
On On
Off Off
Off On
On Off
On On
Off Off
Off On
HMX6800+BC8 Installation and Operation Manual
Table 3-7.)
to
Bank Number
0
1
2
3
4
5
6
7
8
9