Module Status Leds - Imagine communications Selenio 6800 Installation And Operation Manual

Module Status LEDs

Note
If the LED is flashing red,
please contact your Customer
Service representative.
HMX6800+BC8 Installation and Operation Manual
Table 3-10. Monitoring LEDs (Continued)
LED Color Indications Meaning
AUDIO 2 Green
AUDIO 3 Green
AUDIO 4 Green
AUDIO 5 Green
AUDIO 6 Green
AUDIO 7 Green
AUDIO 8 Green
HMX6800+BC8 modules do not have any card-edge alarms. Instead,
module status LEDs on the corner of the module light up if an error is
detected. See Figure 3-4 on page 60
Table 3-11 for a definition of the LED colors.
Table 3-11. Module Status LED Descriptions
LED Color Sequence Meaning
Off
Green
Red
Flashing red
Amber
Presence of AES audio on AES
input 2
Presence of AES audio on AES
input 3
Presence of AES audio on AES
input 4
Presence of AES audio on AES
input 5
Presence of AES audio on AES
input 6
Presence of AES audio on AES
input 7
Presence of AES audio on AES
input 8
for the location of these LEDs, and
There is no power to the module; the module
is not operational.
There is power to the module; the module is
operating properly.
There is an alarm condition.
The module has detected a hardware/
firmware fault.
The module is undergoing configuration.
Chapter 3: Operation
61