Changing Parameter Settings Using Ccs Software - Imagine communications Selenio 6800 Installation And Operation Manual

Changing Parameter Settings using CCS Software

HMX6800+BC8 Installation and Operation Manual
Using CCS software such as Pilot or Navigator, you can access
read-only parameters and adjust controllable parameters in a convenient
tree-view navigation window. If you haven't discovered your module,
follow these steps to start using the HMX6800+BC8 with your CCS
software.
1. With Pilot or Navigator in Build mode, click Tools > Discovery in
the main menu. The Discovery window opens.
2. Click Options, and then click Add.
3. Enter the IP address for the frame that contains the ICE6800+ or
6800+Eth module through which your module will communicate.
Up to eight frames can be connected through an ICE6800+ module,
or up to three frames can be connected through a 6800+Eth
module, to communicate with CCS software. See your
FR6802+QXF Mounting Frames Installation and Operation
Manual for more information.
4. Click OK to close the Add IP address window, and then OK again
to close the Discovery Options window.
5. Click Start.
When your discovery is complete, the Discovery window will show
a list of frames and modules found, and will end with a Discovery
Completed statement.
6. Click Save.
The contents of your discovery are saved to the Discovery folder of
the Navigation pane.
7. Right click in the bottom right corner of the CCS software screen
and choose Control to switch to Control mode.
8. Double click on the HMX6800+BC8 in the Navigation pane to
open its Control window.
9. Double click on the HMX6800+BC8 in the Navigation pane to
open its Control window.
Chapter 3: Operation
49