Mounting And Wiring - Mitsubishi Electric FX2N-485-BD User Manual

FX -485-BD COMMUNICATION BOARD
2N
2.

MOUNTING AND WIRING

2.1
Mounting Procedure
Turn off the power of the programmable controller, and mount the 485BD using the following procedure.
Remove the panel cover from the top face of the base unit.
Connect the connector for programmable controller provided on the 485BD to the board mounting connector
provided on the base unit.
Fix the 485BD to the base unit using the M3 self-tapping screws supplied.
Tightening torque: 0.3 to 0.6 Nm (3 to 6 kgf•cm)
Remove the cut out on the left of the panel cover using a tool such as nippers
or cutters so that the terminal block can. The top face of this terminal block is
higher than the top face of the panel cover of the programmable controller by
approximately 7 mm.
MOUNTING AND WIRING
2
2-1