Creating and Transmitting Screen Data
Section 4-1
[To the File Selection]
Enter filename to newly created screen data.
Return to the "File List".
Pressing the [F8] (Start-up screen) key allows setting of the screen number to be
displayed when the NT20S is booted. (Only effective when using RS-232C)
Transmitting Screen Data to the NT20S
Transmit the screen data created by using the support tool to the NT20S screen
data memory.
Pressing the [F6] (Tmx.) key on the "File List" screen will cause the created screen
data to be transmitted to the NT20S in file units. Pressing [F10] (Next) and then
[F6] (Tmx.) on the "File List" screen will cause the screen data to be transmitted in
screen units. Before attempting data transmission, connect the NT20S and sup-
port tool and set the NT20S to the transmit mode.
For the connection procedure to the support tool, refer to Section 2-3 Connecting
to the Support Tool (page 31). For the transmission of the screen data, refer to
Section 3-6 Registering the Screen Data (page 86).
Note:
When transmitting data in screen units, if changes have been made to memory
tables or direct information in addition to the screens, transmit this changed data
also.
117