Omron NT20S Operation Manual page 117

Various System Settings
98
Data Bits
Stop Bits
Parity Check
Flow Control
Baud Rate
LMP Bit Control
To set and quit the menu, press the [WRT&EXIT] touch switch. To quit without set-
ting, press [Quit].
S When "Disable" is set, the control of lamp display statuses by bits is not possible.
The lamps numbered 0 to 31 can be controlled only by specifying lamp numbers.
S When "Enable" is set, lamp control by bits is possible. This means that the lamps
numbered 0 to 31 can be controlled by specifying either lamp numbers or bits.
However, it is not possible to make "lit"/"flashing" status selections by specifying
lamp numbers: the selection made when the screen data was created remains
effective.
8bits
Quit
1bit
Page
Even
RS/CS
19200bps
WRT&
EXIT
Enable
Section 3-8
Each time the "LMP Bit Control"
touch switch is pressed, the set-
ting option "Enable" alternates
with "Disable".