Omron NT20S Operation Manual page 107

Registering the Screen Data
Operation 1. Connect the NT20S to a PC in which the support tool has been installed and
88
turn on the power to the NT20S.
2. Turn ON the computer and start up the support tool.
3. Enter the "Transmit Mode" by operating the menu of the NT20S as mentioned
below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ TRANSMIT MODE ]
ABORT Tool Mode : NT20S
4. Select a screen data to be transmitted to the NT20S in the File Selection
screen of the support tool, and press the Send key.
5. The NT20S will display the following screen when the screen data is being
transmitted.
[ TRANSMIT MODE ]
Tool → PT
Screen Data
0 KB
ABORT
Tool Mode : NT20S
Section 3-6
Select "Transmit Mode".
The transmit mode is estab-
lished. When using an NT20S-
ST121-EV3/ST122-V1, the
"support tool mode" setting will
be displayed on the bottom line
of the screen, as shown in the
figure to the left (nothing is dis-
played here on the screen of the
NT20S-ST128).