Omron NT20S Operation Manual page 115

Various System Settings
96
Set the support tool mode by the menu operation from the system menu shown
below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
Init. Memory
Memory Switch
MEMORY SW MENU
Comm. Type
Key Sound
Buzzer Sound
Bk light Off
Tool Mode
To quit after setting the selected item, press the WRT & EXIT touch switch. To quit
without setting, press the Quit touch switch. The NT20S will enter the RUN mode.
S When "NT20M" is set, the NT20M compatible mode is established and the termi-
nal can be used as an NT20M.
S When "NT20S" is set, the terminal can be used as an NT20S.
DIP-SW Status
(1/2)
Quit
Host Link
Page
OFF
OFF
None
WRT&
EXIT
NT20M
Section 3-8
Select "Maintenance Mode".
Select "Memory Switch".
Each time the "Tool Mode" touch
switch is pressed, the setting
option alternates
"NT20S" and "NT20M".
(The figure to the left shows the
NT20S-ST121-EV3 screen.)
between