Thermo Scientific AI 3000 Operating Manual page 56

3
Installation
Installing the Sampling System Support on the TRACE 1300/TRACE 1310
38 AI 3000/AS 3000 Sampling System - Operating Manual
Figure 34. Assembling In Gemini Configuration (2)
Guide Pivot
Top Plate Front
A'
3. Guide the three fixing screws into the corresponding fixing holes located on the GC top.
See A', B', and C'.
4. Tighten the three fixing screws.
5. If not already done, mount and fix the guide pivot on each top plate by using the proper
fixing screw.
6. Place the two top plates over the double bottom plate.
7. Guide each retainer and its fixing screw into the sliding slot present on each top plate.
8. Align each retainer fixing screw into the corresponding fixing hole located on the double
bottom plate.
9. Tighten each retainer fixing screw to block the corresponding upper plate to the double
bottom plate.
Retainer
Double Bottom Plate
B'
Guide Pivot
Retainer
Top Plate Back
C'
Thermo Scientific