Enable Custom Messages; Resetting Parameters To Default Values; Format P&P Key; Reset Wellness Key - Technogym CROSS FORMA Service Maintenance Manual

9.1.8. E
NABLE CUSTOM MESSAGES
It is possible to configure whether a custom message is displayed when the machine is in the
standby state. To change the selection, when the display shows the current setting:
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.9. R
ESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter. If the ENTER key is pressed the display will show:
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
At the end of the configuration procedure, hold down the CLEAR key for a few seconds to exit.
The CLEAR key can be pressed at any time to interrupt the procedure and revert to standby mode.
9.1.10. F P&P
ORMAT
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
Press ENTER to confirm. At the end of the formatting procedure, hold down the CLEAR key for a
few seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and
revert to standby mode.
9.1.11. R W
ESET
This function resets the TGS key when the user finishes its cycle of trainings. In particular to start
again from the first training session written on it, as if the TGS key wouldn't have never used
before.
9.1.12. SN
This parameter shows the serial number of the machine.
Page 9.4
CUSTOM MESS. : xxx
CUSTOM MESS.
YES
NO
DEFAULT CONFIG.
KEY
FORMAT P&P
K
ELLNESS EY
CROSS FORMA: Service & Maintenance Manual - rev. 2.1
<default>
CONFIRM ?