Example Of Use - FUTABA 10J Instruction Manual

Trainer
TRAINER
Function
to match the student's level.
The trainer function can be used by connecting the instructor's transmitter to the student's transmitter
the student enters a dangerous situation, control can be immediately switched to the instructor.
● Four operation modes can be selected at each channel.
● The trainer switch is set to switch H.
When the trainer function is used, the snap roll function is automatically
deactivated.
CAUTION
● When the instructor uses a T10J transmitter, set the student s transmitter modulation to PPM (for
conventional frequency transmitter). (When the student uses a T10J transmitter, the modulation
mode does not have to be changed. A PPM signal is always output from the trainer jack.)
● Before flight always confirm that all the instructor and student channels operate normally as set.
● Always insert the trainer cord as far as it will go and take measures so that the cord will not work
loose during use.
● Always remove the high frequency module of the student s transmitter. (For module type)
● Never turn on the student s transmitter power switch.
Trainer function operation modes
● FNC mode: The channel set to this mode can be controlled by the student using the mixing set at
the instructor s transmitter. *Student settings are returned to their initial value in advance. Next,
reverse function makes all channels normal.
● MIX mode: The channel set to this mode is controlled by mixing the instructor and student signals.
Correction rudder is applied by the instructor. When this mode is selected, the student s rate is
reduced to prevent servo overthrow. The student s rate can also be set. *Student settings are
returned to their initial value in advance. Next, reverse function makes all channels normal.
● NOR mode: The channel set to this mode is controlled by signals from the student s transmitter. (The
instructor and student settings must be the same.)
● OFF mode: The channel set to this mode cannot be controlled by the student. It can only be controlled
by the instructor.
However, channels not provided at the student s transmitter are controlled by the instructor regardless of the above
settings.
When other models are selected, the trainer function is deactivated, but the channel settings remain.

Example of use

● When the FUNC mode is set at the stick channel, helicopter stick operation training is possible even
with a 4EX transmitter (4 channels for aircraft).
● Control by the instructor is possible by setting only the training channel matched to the student s
level to the NORM mode and setting the other channels to the OFF mode.
◆ Trainer Cords
Instructor
10J
18MZ,14MZ,
14SG, FX-22, 12Z,
12FG, 8FG, 10C,
9C, 7C, 8J, 6J, 4EX
Use the trainer function under the following conditions:
Student
10C, 9C, 7C, 6EX, 4EX
18MZ,14MZ, 14SG,
FX-22, 12Z, 12FG,
8FG, 10J, 8J, 6J
10J
Trainer code
Student
Trainer Cords
T12FG (FUTM4405)
T12FG (FUTM4405) and 9C
(FUTM4415) Trainer Cords
(Common)
Teacher
93