Advertisement
Available languages
Available languages
Radio Controlled Time:
The clock automatically starts scanning the RF 433MHz signal to register new thermo sensor
unit after new batteries inserted. After registered the thermo sensor or press "SEARCH" button to
stop scanning, The clock will then automatically starts scanning the DCF time signal (
on the LCD)
The clock automatically scans the time signal at 3:00a.m. everyday to maintain accurate timing.
For failed reception, scanning stops (
5:00a.m., and 6:00a.m.
The clock manually scans the time signal by holding buttons "▲" & "▼ ". For failed reception,
scanning stops (
received. e.g. scan at 8:20 failed, it will received again at 9:00; 10:00; 11:00; 12:00.
Stop scanning by holding "▲" & "▼" buttons.
*
flashes indicate now is receiving the DCF signal
turns on indicate signal received successfully
Manual Time Setting:
Press "MODE"(A) button to change the display content:
Radio Controlled Time
When the Time is displayed on LCD, hold "MODE" (A) button for 2 seconds to enter Time setting
mode.
Press or hold "▲" (C ) & "▼" (B) to adjust the Hour, Minutes, Time Zone, Year, Language of week
day, Year, Month and Day.
Press "MODE" (A) button to confirm each setting
The TIME SETTING mode will automatically exit in 8 sec without any adjustment.
Snooze Alarm Clock Function:
Press "ALARM ON/OFF" (E) button to switch the alarm on „
Press "MODE" button twice to turn to Alarm Time Display, hold "MODE" button 2 seconds (Hr digit
blink) to enter Alarm Time setting mode. Press "▲"(C) or "▼" (D) buttons to adjust the Alarm
Time.
Press "SNOOZE/ PROJECTION/LIGHT" button (H) when alarm is alerted. The alarm snoozes for
8 minutes, then it alerts again
Press "ALARM ON/OFF"(E) button to switch off the alarm. ("
on LCD disappear) and repeats again at 4:00a.m.,
on LCD disappear) and repeats again in the next 4 hours (4 times) until
Time + week
ENG - 21
Alarm Time
"appears on the LCD.
flashes
" disappear)
ENG
Advertisement
