Point To Point Communication With The Programming Protocol; Description; The Command List Of The Integrated Editor Which Is Available In Terminal Mode - ABB 07CR41 Operating Manual

6.4 Point to point communication with the programming protocol

6.4.1 Description

6.4.2

The command list of the integrated editor which is available in terminal mode

3
Communication
Programming mode
Figure 10: Example of programming with the 907 PC 331 software
This example uses the serial interface of the basic unit and is reserved for devices with an
ABB programming interface (Figure 8).
All variable values can be read or written by this protocol without the need for a configuration
or any particular program in the basic units. You simply use the grey 07 SK 50 or 07 SK 52
programming cable.
The following communications parameters are permitted:
- 9,600 baud
- 8 data bits
- 1 stop bit
- No parity
The terminal mode is used with the active mode of the 40 and 50 series basic units.
The basic unit can be programmed and tested. All the operating functions are available.
Communication is in ASCII protocol.
The terminal mode can be used with a terminal or the AC31 907 PC 331 programming and
test software.
A detailed description of the terminal mode can be found in the programming software
documentation.
The list of the various commands can be displayed with the command H<CR>. See the next
table.
40 or 50
series
6 – 14
Advant Controller AC 31 / Issued: 01.99