Compressor Area Electrical & Mechanical Components - Sub-Zero 700TC-3 Service Manual

Component Access/Removal
COMPRESSOR AREA ELECTRICAL AND MECHANI-
CAL COMPONENTS
Icemaker Water Valve Removal
(700TC/I-3, 700TF/I-3 & 736TC/I-3)
The icemaker water valve assembly is located at the
right side of the compressor area next to the condenser,
and is attached to the valve bracket with screws.
NOTE: Before accessing the icemaker water valve,
turn off water supply to the unit.
To remove the water valve, the kickplate/grill will need
to be removed first and the unit tray slid out. To slide
the unit tray out, extract the two screws that secure the
tray to the unit, located at the front right and left cor-
ners. Grab the front flange of the tray and pull forward.
(See Figure 7-39), then (See Figure 7-40):
1. Disconnect inlet water tube from the valve inlet by
pushing collar around tube toward valve, while
pulling inlet water tube away from valve.
2. With a Phillips screwdriver, remove screws from
valve bracket.
3. Lower valve and pull forward.
4. Disconnect valve electrical leads.
5. Disconnect outlet tube from the valve outlet by
pushing collar around tube toward valve, while
pulling outlet water tube away from valve.
#3758412 - Revision B - December, 2006
Integrated
Integrated
(700-
(700-
Figure 7-39. Sliding Unit Tray Out
Outlet Tube
Figure 7-40. Water Valve Removal, TC/I-3, TF/I-3
7-18
3
3 Series
Series
T ALL)
T ALL)
Mounting Screws
Inlet Tube
Screw
Screw
Electrical Leads
Water Valve