Door Assembly; Upper And Lower Hinge Assembly - Sub-Zero 700TC-3 Service Manual

Integrated
Integrated
Door Assembly Removal (All Models)
The door assembly is held in place with Allen-head
screws that pass down through the arm of the top hinge
assembly and up through the arm of the bottom hinge
assembly, then into the door. These mounting screws
are concealed by a hinge cover on each hinge arm.
The hinge covers are held in place by tabs that fit into
notches in the hinge arms.
NOTE: Removing the top drawer first will make this
task easier.
To remove a door assembly (See Figure 7-6):
1. Open door and removing both hinge covers.
2. With Allen-head wrench, extract the two inner-most
door mounting screws from top and bottom hinge
arms, leaving the two outer-most screws in place.
3. Close door and extract the outer-most door mount-
ing screws from bottom hinge arm.
4. Extract the two outer-most door mounting screws
from top hinge arm.
5. Lift door from unit.
Upper and Lower Hinge Assembly Removal
(All Models)
The hinge assemblies are attached to hinge mounting
brackets with Allen-head bolts.
To remove a hinge assembly, you will need to remove
the door assembly first. Then, extract the Allen-head
bolts from the appropriate hinge mounting bracket and
pull the hinge assembly from the unit. (See Figure 7-7)
3
3 Series
Series
(700- T ALL)
(700- T ALL)
2
Remove two outer-most
screws at bottom hinge
first then at top, with door
closed.
Hinge Cover
7-5
Component Access/Removal
Hinge Arm
Figure 7-6. Door Assembly Removal
Bolt
Hinge Arm
Figure 7-7. Hinge Assembly Removal
#3758412 - Revision B - December, 2006
Remove two inner-most
1
screws at top and bottom
hinge with door open.
o r
D o
b l y
s e m
A s
Bolt