Replacing Pc Door On Ice & Water Models; Designer Doors - Fisher & Paykel 635 Active Smart Service Manual

11.1.11 Replacing PC Door On Ice & Water Models

11.1.11.1 Designer Doors

• Turn the power off to the refrigerator.
• Turn off the water (if connected).
• Remove the display module and unclip the
harness from the display (refer to Section 11.1.6).
• Disconnect the water tube from the check valve.
• With the door in the open position, remove the
hinge cover.
NOTE: Removing the hinge cover will allow a
screwdriver to be used to remove the hinge cover
trim without damaging the hinge cover.
• With a flat bladed screwdriver, and using the
hinge bracket as a lever, gently lever the centre
of the hinge cover trim upwards, ensuring that it is
raised evenly.
• Lift the hinge cover trim from the door.
• Close the door.
• Unplug the wiring harness edge connector and remove the three hinge bracket mounting screws.
• Rotate the hinge bracket and lift clear.
• Unclip the water tube and harness from the guide
assembly, noting its layout for refitting.
1. Lift cover
81
321144
2. Pull forward