Block/Edge Connectors - Fisher & Paykel 635 Active Smart Service Manual

12.23 Block/Edge Connectors

Should a connector need replacement, it is important that the wiring connections be kept in the correct order
to the connector. The wiring harness uses one colour of wire throughout all circuits. The circuit wiring
should be traced with the aid of a multimeter before a connection is made.
When wiring any DC voltage supply or components, it is important that the correct polarity be observed.
The following diagrams show all these connectors and their Fisher & Paykel part numbers.
To make a connection on an edge connector, cut the wire end square and insert it into the correct location
on the edge connector itself. With the wire fully inserted, apply pressure to the terminal, which will lock the
wire and terminal together.
If possible, when replacing a connector the connections should be made one at a time. For example, first
cut the wire in pin 1 of the old connector and insert it into pin 1 on of the new connector. Push the pin fully
home to lock the wire in place, and then move on to pin 2.
Note that these connectors contain a wall between the cavities to 'code' or polarize the connector. This is
especially important in the case of the 4 and 6 way connectors in the power/control module. Also note that
the replacement connectors are un-coded (to reduce the number of spare parts required) and therefore care
must be taken that the connector is replaced in the correct socket. Check the wiring diagram and labelling
on the power/control module if unsure.
JST PLUGS AND SOCKETS
TYPE
JST PLUG
2 PIN
4 PIN
6 PIN
8 PIN
JST PIN TERMINAL
(Fits the plug above)
JST SOCKET
2 PIN
3 PIN
4 PIN
6 PIN
8 PIN
JST SOCKET TERMINAL
(Fits the socket above)
RETAINER
2 WAY
3 WAY
(Common to both plugs
and sockets)
DESCRIPTION
YLP-02V
YLP-04V
YLP-06V
YLP-08V
SYM-01T-P0.5A (26/20 AWG)
SYM-41T-P0.5A (20/16 AWG)
(There are two sizes of terminals
to suit the wire gauges)
YLR-02V
YLR-03V
YLR-04V
YLR-06V
YLR-08V
SYF-01T-PO.5A (26/20 AWG)
SYF-41T-PO.5A (20/16 AWG)
(There are two sizes of terminals
to suit the wire gauges)
YLS-02V
YLS-02V
97
321144
PART NUMBER
819611
819612
819613
819614
819609P
819610P
(Sold as packet of 10)
819615
819616
819617
819618
819619
819607P
819608P
(Sold as packet of 10)
819620
819621