Display Module Replacement - Fisher & Paykel 635 Active Smart Service Manual

321144
11.1.6

Display Module Replacement

The display module is located on the front of the door.
To remove the module:
Step 1
Disconnect the refrigerator from the power supply.
Push the tabs upwards and gently pull the panel
forward once the tabs release.
A small screwdriver or key may need to be used to
dislodge the tabs from the housing.
Step 2
Two locating pins on the base of the front panel hold
the housing at the bottom.
NOTE: The housing cannot be removed, as wiring
looms prevent its removal.
Step 3
Disconnect the RAST connectors from the module.
Pull the two bottom tabs forward.
Remove the module.
Step 4
Refit in reverse order.
Ensure the wiring is placed and clipped into the
correct position.
Ensure the water hose is in the correct position prior
to clipping the panel into position.
If necessary, replace the water hose between the
door hinge and the dispenser.
Locating pins
76