Fc Drawer Removal - 900 Models; Refitting Of The Fc Drawer - Fisher & Paykel 635 Active Smart Service Manual

12.7

FC Drawer Removal - 900 Models

1. Remove all Ice and Storage Bins as in Section 12.6.
2. Push the locking tab on each of the FC bracket mount slides as shown in Photo 12.7
3. Once the tabs have been released, the FC drawer can be lifted up.
4. Locating tabs on the bracket mount slides need to be removed out of the slide to remove the FC
drawer.
Note: The anti-wracking device comes out with the drawer.
Push Locking Tab in to release bracket from slide.
12.7.1

Refitting Of The FC Drawer

1. There are two locating tabs on the drawer that are required to be fitted first. (Refer Photo 12.7.1)
Step 1
2. Align the rear locating tab into the slot as shown in step 1.
3. Align the front locating tab into the slot as shown in step 2.
4. Fit the anti-wracking bar into the wracking pinion gear ready to fit to the drawer.
5. Both anti-wracking pinion gears need to be fitted simultaneously. (If this is not achieved, damage to the
gearing may occur or the drawer will not close correctly.) Refer Photo 12.7.1.1.
Photo 12.7
Step 2
Photo 12.7.1
91
Locking Tab
321144