Table of Contents
Advertisement
12.24 Fan Cover Removal Tool (T Models Only)
The following illustration shows a tool that can be made in your workshop. This tool can be used to release
and remove the freezer compartment fan cover in the Active Smart
the tool can be made from a screwdriver with a shaft length of approximately 200mm (8 inches) long and 4.5
3
mm (
/
inch) diameter.
16
B models are removed by grasping the bottom of the evaporator cover and pulling up and forward.
12.25 Active Smart
Testing a PC or FC fan motor with a multi meter is not possible, due to the electronics contained within the
motor. The simple way to test a fan motor is to apply a DC voltage with a 9-volt battery.
Parts required are:
Component
JST Plug 2 Pin
JST Pin Terminal
A 9-volt battery terminal connector obtainable from any electronic goods supply store.
A 9-volt battery
NOTE: When wiring the plugs, ensure that the polarity is correct, as the motors will not run if the polarity is
reversed.
Diagram 12.24
®
PC/FC Fan Motor Tester
Qty
1
2
99
®
"T" model refrigerators. If preferable,
Part Number
819611
819610
321144
Hide quick links:
Advertisement
Table of Contents
