USING YOUR WATER DISPENSER – ICE & WATER MODELS ONLY
TO ENSURE YOUR APPLIANCE OPERATES CORRECTLY PLEASE REFER TO THE
INSTALLATION INSTRUCTIONS BOOKLET SUPPLIED WITH THIS PRODUCT.
Before using your water dispenser
Ensure your ice and water system has been correctly installed by following the
installation instructions booklet supplied.
To flush the water filtration system:
Ensure your refrigerator is switched on, and the isolation
●
●
faucet has been connected and turned on.
Run your water dispenser pad until water dispenses, this
●
●
will displace trapped air in the water tank and filter system.
This will take at least 2 minutes. Once water has dispensed,
rest the dispenser pad for 2 minutes.
Dispense and discard 4 qt (4 L) of water, then rest the
●
●
dispenser pad for a further 2 minutes.
Dispense and discard a further 4 qt (4 L) of water. Failure to
●
●
do this will result in excessive dripping from your dispenser.
Please note, once installation is complete a few drips may
●
●
appear out of the dispenser over the next few days to clear
the remaining trapped air.
Ensure your refrigerator has cooled for at least 2 hours
●
●
before use.
You are now ready to enjoy water from your water dispenser.
Dispensing
Your water dispenser has been designed for one-handed operation.
●
●
To dispense water, gently press the dispensing pad using a glass or container.
●
●
To stop the flow of water, simply pull your glass away from the dispensing pad.
●
●
Please remember that pressing very hard against the dispensing pad will not encourage
●
●
the dispenser to operate faster or produce greater quantities of water.
IMPORTANT!
To avoid damage to property or personal injury do not put hands, fingers or objects
up the dispenser opening.
Dispenser lock
The dispenser lock located on the external display can be
activated to prevent water from being dispensed. This is
useful when you are cleaning the external display or when
there are small children around.
To activate dispenser lock press the
●
●
The LED above the button will illuminate.
When the dispenser pad is pressed several beeps will sound
●
●
indicating to the user that water cannot be dispensed.
To deactivate dispenser lock and allow water dispensing,
●
●
press the
button for 4 seconds. The LED above the button
will no longer illuminate.
14
button for 4 seconds.
Water dispenser
Dispenser lock