Removing The Front Or Rear End Caps - Emerson FB1100 Instruction Manual

Figure 2-3. Retaining Clamp in Place
To loosen or tighten the screw, use a 3mm hexagonal wrench. When tightening, torque to 12 in-lbs
(1.4 N m).
Figure 2-4. Retaining Clamp and Screw
2.6.2

Removing the Front or Rear End Caps

DANGER
EXPLOSION HAZARD: Never remove end cap(s) in a hazardous location. Removing end cap(s) in a
hazardous location could result in an explosion.
Note
If you need more leverage place a long screwdriver or other appropriate tool across the two
notches in the end cap to act as a pry bar (see
Figure 2-5: Removing or Tightening the End Cap with Long Screwdriver
1. Remove the retaining clamp (if present). (See Section 2.6.1)
Installation
Emerson FB1100 Flow Computer Instruction Manual
Figure 2-5).
D301752X012
July 2017
15