Removing The Front Or Rear End Caps; Retaining Clamp And Screw; Front (Left) And Rear (Right) End Caps - Emerson FB1200 Instruction Manual

Figure 2-6: Retaining Clamp and Screw
2.6.2

Removing the Front or Rear End Caps

DANGER
EXPLOSION HAZARD: Never remove end cap(s) in a hazardous location. Removing end cap(s) in a
hazardous location could result in an explosion.
Note
If you need more leverage place a long screwdriver or other appropriate tool across the two
notches in the end cap to act as a pry bar (see
Figure 2-7: Removing or Tightening the End Cap with Long Screwdriver
1.
2.
Installation
Remove the retaining clamp (if present). (See
Grasp the end cap (front or rear).
Figure 2-8: Front (left) and Rear (right) End caps
Emerson FB1200 Flow Computer Instruction Manual
Figure 2-7).
Section 2.6.1)
D301782X012
March 2019
17