Table of Contents
Advertisement
Preparing MiniCluster For Service
Preparing MiniCluster For Service
Most service procedures are performed on a single appliance component. Service procedures
that require a single compute node to be powered off can be performed without shutting down
the entire MiniCluster. Before powering off any component for service, refer to the Getting
Started Guide or Administration Guide for any special instructions or commands that must be
performed on the MiniCluster to prepare it for service.
Note -
to the SPARC S7-2 documentation libraries. Use your browser's Back button to return to the
MiniCluster library.
"Safety Information" in SPARC S7-2 Server Service Manual
■
"Service Tools" in SPARC S7-2 Server Service Manual
■
"Find the Server Serial Number" in SPARC S7-2 Server Service Manual
■
"Locate the Server" in SPARC S7-2 Server Service Manual
■
"Prepare to Power Off the Server" in SPARC S7-2 Server Service Manual
■
"Power Off the Server" in SPARC S7-2 Server Service Manual
■
"Disconnect Cables From the Server" in SPARC S7-2 Server Service Manual
■
"Prevent ESD Damage" in SPARC S7-2 Server Service Manual
■
"Extend the Server to the Service Position" in SPARC S7-2 Server Service Manual
■
"Remove the Server From the Rack" in SPARC S7-2 Server Service Manual
■
"Open the Server Fan Door" in SPARC S7-2 Server Service Manual
■
"Remove the Top Cover" in SPARC S7-2 Server Service Manual
■
Component Service Categories
The server components and assemblies that can be replaced in the field fall into three
categories:
Hot-service, replaceable by customer
■
Cold-service, replaceable by customer
■
Cold-service, replaceable by authorized service personnel
■
Cold service procedures require that you shut the server down and unplug the power cables that
connect the power supplies to the power source.
14
Oracle MiniCluster S7-2 Service Manual • March 2017
The links in the following list take you to instructions outside of the MiniCluster library
Advertisement
Table of Contents
