Akai PDP42Z5TA Service Manual page 135

9. PACKING
Box packing (5 modules per each Box)
1. Prepare to Module & Packing sheet (Grid)
-Put the Module on the printed surface as four
holes at the sheet locate to down of the module
like the picture below.
-It has to use some supporter of 10cm height
in the bottom of the module.
2. Wrapping Packing sheet
- Fold the packing sheet, align 4 holes of the
sheet with support sides of the module and then
tapping.
-Do not fold the right/left side of the sheet.
Hole for Support side
3. Connect Cover Plate
-Connect M4 screw(6 positions)
-Screw torque: 17~20kgf.cm
-The shape of Cover Plate is same
(Top/Bottom, Right/Left)
Product Specification of 42XGA PDP Module
Tape 1ea
133／148
4. Prepare bottom Box for Packing
-The arrow direction at the bottom packing
Should be front side.
5. Insert wrapped modules with top packings
-Insert wrapped modules arrow direction of the
bottom packing in the bottom box.
-Top packings should be inserted front side
like the picture below.
6. Put Box, Tapping and Banding
-Put Box on Module(the direction of Box should
be same direction as front side of Module.
-Box Tapping should be down to 10cm at
right/left side like picture as shown below.
- Box banding by using the location of Banding
guide.
10cm
Banding guide