Vegetable Compartment Disassembly - Sharp SJ-XF50X-T Service Manual

3) Remove the aluminum tape that fastens the lead
wire to the drip tray.
Screw Heater AL
4) Remove two screws, and remove the heater AL.
5) Open the heater fastening part of the heater AL to
the right and left, and replace the heater.
Fastening part
6) Insert the lead wire in the groove of the drip tray,
and apply the aluminum tape to fasten the lead
wire.
Lead wire
7) Re-mount the evaporator in the original condition.
CAUTION
• Put the bottom of the evaporator on the rib of the
drip tray, and place the projection of the food liner
at the position shown in the figure.
• Set the accumulator piping angle as shown in the
figure.
• Make sure that the pipe is not remarkably
deformed.
Fastening part
Screw
Aluminum tape
Heater
Aluminum tape
Groove of drip tray
Accumulator
4. VEGETABLE COMPARTMENT
DISASSEMBLY
Main component
-
1. Remove the V door.
2. Remove the Damper cover.
Remove one screw.
Pull the Damper cover while inserting a flathead
screw driver, etc., to have some gap.
Flathead screwdriver etc,
3. Remove the Damper.
Close the flap if the flap is closed.
Disconnect one connector and pullout the Damper.
4. Remove the G-thermistor.
Pull out the
connector
31
SJXF50XT
Contained parts
Damper, G-thermistor
(V-thermistor)
Screw
Damper cover
: claw
G-thermistor
Close the flap
Damper