Sharp SJ-XF50X-T Service Manual page 51

3. Cover Ice cube tray AT with Ice heater cover T.
* Set Ice heater cover T so as to "
* Tightening toruque is 0.5N•m.
4. Put rib of Ice senser in groove of ice maker ass'y, and fi x Ice senser to Ice maker ass'y by tapping screw.
* Put head of Ice senser points fi nal gear of Ice maker ass'y.
* Use jig to prevent variability fi xing Ice senser.
* Tightning torque is 0.5N m.
5. Insert the assembly of Step 3 to the assembly of Step 4.
• Make sure that the ice cube tray AT is attached in the right direction.
(The ice making section comes to the mounting foot side of the ice maker ass'y)
• Insert it all the way inside the fi nal gear so that it fi ts fi rmly.
" marking side is on axis of Ice cube tray AT.
Ice heater cover T
Screw
Ice maker ass'y
Final gear
Move this direction
(remove backlash)
Ice cube tray AT
Marking " "
Axis
Ice cube tray AT
Ice senser
Groove Rib
Ice maker ass'y
Screw
Ice maker ass'y
51
SJXF50XT
Head