Table of Contents
Advertisement
Configuring PC Agilent IO Config for LA connection
The 89601A Software automatically installs the Agilent IO Libraries Suite on your
PC if they are not already installed.
To configure PC Agilent IO Config for a LA connection:
1. On the PC with the 89601A software, select: Start > Programs > Agilent IO
2. Add an instrument.
3. To verify that the computer recognized the instrument, expand LA in the
Agilent Connection Expert can not find the Infiniium scope if the scope
NOTE
application is not running.
When the 89601 software locates an instrument, it locks onto the instrument so
NOTE
only the 89600 software can communicate with it. This will prevent Agilent IO
Libraries from any communication with these instruments and cause the green
checkmark to become a red X in Connection Expert. You can disconnect the
Chapter 7
Libraries Suite > Agilent Connection Expert.
Auto discover cannot be done on LAN devices so you must manually add the
instrument.
a. Click on LA in the Instrument I/O on this PC section.
b. Click Add an instrument in the Task Guide section. The LAN selection
should be highlighted but if not, highlight it.
c. Click OK.
d. Select IP address in the LAN instrument dialog box and enter the IP
address of the instrument. You can also use Hostname if it is known.
e. Click OK.
Instrument I/O on this PC section. Connection Expert lists all instruments and
their addresses.
Configuring Infiniium Windows XP Scopes
Configuring PC Agilent IO Config for LA connection
119
Advertisement
Table of Contents
Troubleshooting
