Configuring Pc Networking For A Crossover Cable Configuration; To Configure Pc Networking For A Crossover Cable Configuration - Agilent Technologies 89604 Installation And Vxi Service Manual

Configuring PC etworking for a Crossover Cable Configuration
Configuring PC etworking for a Crossover Cable
Configuration
Complete the following procedure to configure a PC for a Crossover Cable
configuration.

To configure PC networking for a crossover cable configuration:

1. On your PC, open the Control Panel (Start > Control Panel).
2. For Windows XP, click etwork Connections > Local Area Connections >
Properties.
For Windows Vista, click View network status and tasks in etwork and
Internet > View status in Local Area Connection > Properties.
This will display the Local Area Connection Properties dialog box.
3. For Windows XP, select Internet Protocol (TCP/IP) and click Properties.
For Windows Vista, select Internet Protocol Version 4 and click Properties.
This will display the Internet Protocol (TCP/IP or Version 4) Properties dialog
screen.
4. Select Use the following IP address and enter the IP Address for the PC you
created in step 1 of "Configuring Windows XP Infiniium Networking for a
Crossover Cable Network" (page 116)
enter a subnet mask of 255.255.255.0.
5. Click OK in the Internet Protocol (TCP/IP or Version 4) Properties dialog box.
6. Click OK or Close in the Local Area Connection Properties dialog box. If
Windows prompts you to reboot your PC, click Yes. If not, close any open
dialog boxes.
7. After your PC reboots, the PC is ready for setting up the Agilent IO Config
software. Go to "Configuring PC Agilent IO Config for LAN connection"
(page 119).
Chapter 7
Configuring Infiniium Windows XP Scopes
(this example uses 192.168.0.2.), and
117