Connection And Installation; Check Hardware; Hard Drive Installation - Amcrest AMDV4M4 User Manual

3. Connection and Installation

3.1 Check Hardware

When you receive the DVR system in the packaging, unpack it, and check all sides of the DVR to see if there is any
physical damage. The protective materials used for the packaging of the DVR can protect most accidental damage
during transportation, but to ensure that your equipment is operating as expected, it is recommended to inspect
the product before proceeding further.
On the DVR unit, check specifically that the label on the bottom of the DVR is not damaged. The serial number of
the unit is usually needed to provide support.
Please check that all required items for your DVR are present and accounted for. To check what is included with
your purchase, go to http://amcrest.com/hdcvi-security-camera-systems.html/ and find the product you
purchased, then scroll down and click the "What's Included" tab. If any item is missing, please contact us as soon
as possible so we can send you the missing component.

3.2 Hard Drive Installation

You can refer to the Appendix for recommended HDD brands and models. Please use a HDD of 7200rpm or higher.
Please follow the instructions below to install a hard disk drive (HDD).
All the figures listed below are for reference only. Slight differences may be found on the front or rear panel.
1. Loosen the screws of the
cover and side panel.
upper
2. Attach four screws in the HDD
(Turn three times).
3. Place the HDD in accordance with
the four holes on the bottom.
14