Table of Contents
Advertisement
Factory Reset Procedures
A factory reset will revert the device back to its original factory settings. To begin the process, you will
need to remove the NVR cover. Use a Phillips head screwdriver to remove the screws on the back/sides
of the NVR. Once the screws have been removed, lift the lid to expose the NVR's motherboard. Please
make sure the NVR is powered on as well to complete the process.
On the motherboard you will notice a small black button. This is the factory reset switch for your NVR:
To factory reset the NVR, press, and hold the factory reset switch for 4 – 5 seconds and unplug the power
adapter. Once power is removed from the unit, press, and hold the factory reset switch for an additional
4 - 5 seconds and power plug the adapter back into the unit. Continue pressing the factory reset button
until you hear a beep and release. The device will be reset to its original factory settings.
Device Installation
After applying power to the NVR, the system will turn on. Allow the NVR to finish loading. The Device
Initialization screen will appear. Select your location, language, and video standard then click Next to
continue.
Select your time zone as well as current date and time. Click Next to continue.
7
Advertisement
Table of Contents
