5.6 Log Out
The logged in user can logout by using the
out, the DVR Web Access will return to the login screen, where another user may login. Below is a screenshot of
the login screen:
6. FAQs/Troubleshooting
1. The DVR does not boot up properly.
Below are a few possible reasons why this may be occurring:
•
The power input is not correct voltage.
•
The power cable connection is not secured correctly.
•
The power button is damaged or malfunctioning.
•
The firmware was upgraded incorrectly.
•
There is an HDD malfunction, or something is wrong with the HDD cable.
•
There is damage to the DVR's main motherboard.
2. DVR often automatically shuts down or stops running. Below
are a few possible reasons why this may be occurring:
•
The input voltage is too low or is not stable.
•
There is an HDD malfunction, or something is wrong with the HDD cable.
•
The power button is damaged or malfunctioning.
•
Video output signal is not stable.
•
The insides of the DVR have accumulated too much dust.
•
The temperature is either too hot or too cold.
•
The hardware is malfunctioning.
3. The system does not detect a hard drive.
Below are a few possible reasons why this may be occurring:
button near the top right hand corner of the screen. Once logged
129