Connection And Installation; Check Hardware; Hard Drive Installation - Amcrest AMDVTENL8 User Manual

1080p-lite

Table of Contents

Press middle

Switch the items in the check box.

button

Page up or page down

Move mouse

Select current control or move control

Drag mouse

Select motion detection zone

Select privacy mask zone.

3. Connection and Installation

When you receive the DVR system in the packaging, unpack it, and check all sides of the DVR to see if there is

any physical damage. The protective materials used for the packaging of the DVR can protect most accidental

damage during transportation, but to ensure that your equipment is operating as expected, it is

recommended to inspect the product before proceeding further.

On the DVR unit, check specifically that the label on the bottom of the DVR is not damaged. The serial number

of the unit is usually needed to provide support.

Please check that all required items for your DVR are present and accounted for. To check what is included

with your purchase, go to http://amcrest.com/hdcvi-security-camera-systems.html/ and find the product

you purchased, then scroll down and click the "What's Included" tab. If any item is missing, please contact us

as soon as possible so we can send you the missing component.

You can refer to the Appendix for recommended HDD brands and models. Please use a HDD of 7200rpm or

higher.

Please follow the instructions below to install a hard disk drive (HDD).

All the figures listed below are for reference only. Slight differences may be found on the front or rear panel.

1. Loosen the screws of the

cover and side panel.

upper

2. Attach four screws in the HDD

(Turn three times).

3. Place the HDD in accordance with

the four holes on the bottom.

Table of Contents