Hard Disk Drive - Sony HSR-1 Service Manual

3-4-3. Hard Disk Drive

Note : Be careful not to give any shocks to hard disk when removing and attaching the hard disk unit.
Caution for Handling the HDD
Refer to "Caution for Handling the Unit with Built-in HDDs" (described after Manual Structure) for handling the hard disk
drive unit and hard disk drive, and perform operations with extra care.
Moreover, pack the failed hard disk drive using specified packing materials when a failure occurs in the hard disk drive,
then contact Sony's sales organization.
. HDD cushion
It is recommended to use the HDD cushion for protecting the hard disk drive on operating.
. Shockless torque screwdriver
Use the shockless torque screwdriver when tightening the screws during replacing the hard disk drive. If the traditional
torque screwdriver is used, it may be applied a fatal shock to the hard disk drive by the click of torque screw driver. Be
sure to use the shockless torque screwdriver.
When the set torque is reached using the shockless torque screwdriver, the shockless screwdriver turns free approx.90 d
without shock.
Tools
Torque screwdriver's bit
(+3 mm, length=50 mm)
HDD cushion
Shockless torque screwdriver (12 kg.cm) : J-6530-070-A
Note : Be sure to use the specified shockless torque screwdriver when tightening screws described in this section.
Never use a ratchet-type traditional torque screwdriver.
3-10
: J-6323-430-A
: J-6530-060-A
HSR-1/1P
HSR-2/2P