Maintenance Menu (Enhanced Menu) - Sony HSR-1 Service Manual

Menu Items
Display Char. display
Layer 2 Layer 3 Layer 4
>>>Menu
PARALLEL INm MENU
INPUT (n PIN)
SET/YES >>>Set/Yes
(continued) (continued)
>>>Reset/No
RESET/NO
B >>>Left
b >>>Right
v
>>>Down
V >>>Up
>ParaOutput
PARALLEL OUTPUT
>>n PIN
OUTm (n PIN)
NO USE >>>No use
>>>Stop St
STOP
REC >>>Rec St
>>>Play St
PLAY
F.FWD >>>FFWD St
>>>REW St
REW
SERIES REC >>>SeriesRec
>>>Time Set
TIME
ADJUSTMENT
ALARM >>>AlmRetrn
RETURN
ALARM >>>Alarm
TAPE END >>>Tape End
TAPE EXIST >>>TapeExst
ERROR >>>Error
VIDEO LOSS >>>Videolos
>>>Pre-end
PRE END
PARALLEL OUT VOLTAGE >POutVolt
OUTm (n PIN) >>n PIN
>>>Open
OPEN
5V >>>5V
>>>12V
12V
4-14
Chapter 4 Menu Operations
Contents
Function the same as those on the menu operation block on the
front panel.
For assigning a function to each output pin (8 outputs) of the
PARALLEL I/O connector on the rear panel.
m = 1 to 8, n = pin number 15 to 18, 33 to 36
Outputs no signal.
Outputs status signals to indicate the operating statuses of the
recorder.
Outputs the Series-recording signal.
Outputs the clock set signal when the internal clock counts 00
minute 00 second.
Outputs a signal upon return from alarm recording
Outputs a status signal to indicate that alarm recording is in
progress.
Outputs a signal when tape end is reached during
recording.
Outputs a signal when a cassette is in the recorder.
Outputs a signal when an error occurs in the recorder.
Outputs a signal when the video input from a camera set to
"CONNECT" is lost.
Outputs a signal when the tape remaining becomes less than 3
minutes based on the tape length.
For setting the output voltage from each output pin (8 outputs)
of the PARALLEL I/O connector on the rear panel.
m = 1 to 8, n = pin number 15 to 18, 33 to 36
Outputs with OPEN/0 V.
Outputs with 5 V.
Outputs with 12 V.

Maintenance Menu (Enhanced Menu)

The Maintenance Menu is an enhanced menu and is
displayed only when MENU GRADE is set to ENH on
the top menu.
Monitor Display
SETUP MENU
MAINTENANCE MENU
HOURS METER
VERSION DISPLAY
Display Char. display
Layer 2
HOURS METER >HoursMeter
>Ver Disp
VERSION DISPLAY
Character display
Mainte Menu
↓
Press the b key.
>HoursMeter
The Maintenance menu item selected when you left the
menu the last time is displayed.
Contents
Enters the mode to check the hours meter.
For the checking procedure, see "Regular Checks" on page
6-2.
Shows the software version.
4-15
Chapter 4 Menu Operations