Removal And Attachment Of The Cabinets - Sony HSR-1 Service Manual

3-3. REMOVAL AND ATTACHMENT OF THE CABINETS

3-3-1. Top Panel
Removal
1. Remove the four screws.
2. Slide the top panel in the direction of A as shown by the arrow.
3. Remove the top panel.
Attachment
1. Attach the top panel by reversing the removal procedure from step 3 to 1.
Note : Insert claws of the top panel in between the front panel and front frame.
3-3-2. Front Panel
Removal
1. Remove the top panel. (Refer to section 3-3-1.)
2. Remove the three screws.
3. Disengage the two square holes of the front panel from the claws of the front frame as shown on the next page.
4. Open the front panel in the direction of B as shown by the arrow.
5. Remove the flexible card wire (CN103) from the KY-425 board.
Attachment
1. Insert the flexible card wire (CN103) to the KY-425 board.
2. Insert the two claws of the front frame to the notches of the front panel as shown.
3. Engage the two square holes of the front panel with the two claws of the front frame as shown on the next page.
4. Attach the front panel by reversing the removal procedure from step 2 to 1.
3-3-3. Bottom Panel
Removal
1. Remove the ten screws.
2. Slide the bottom panel in the direction of C as shown by the arrow.
3. Open the side panels of the bottom panel in the direction of D, and remove the bottom panel.
Attachment
1. Attach the bottom panel by reversing the removal procedure from step 3 to 1.
3-4 HSR-1/1P
HSR-2/2P