Setting The Pre-Reverse Time (Hsr-2/2P Only) - Sony HSR-1 Service Manual

Settings
3
To change the password, enter a new password
twice in the same manner as when you set the
previous one, and press the SET key.
To delete the password, press the RESET key
without entering any number.
If you forget the password
Consult your Sony dealer.
To releasing the key lock using
Passwords
Press the LOCK key in key lock status (the LOCK
lamp is lit).
When the password(s) have been set, a message
requesting a password appears.
PASSWORD
PLEASE INPUT PASSWORD
– – – –
SHIFT : M
INPUT : NUM KEY
ABORT : LOCK KEY
DATA SET : SET KEY
By entering a password, you can enable some or all of
the locked keys.
To release the key lock of Level 1 only
Enter the password of Level 1 and press the SET key.
The LOCK lamp slowly flashes 1) and the functions
specified for Level 1 are enabled.
To release the key lock of Levels 1 and 2
Enter the password of Level 2 and press the SET key.
1)
The LOCK lamp promptly flashes and the functions
specified for Levels 1 and 2 are enabled.
..........................................................................................................................................................................................................
1) If no password has been specified for the higher level(s),
the LOCK lamp goes out, and all the recorder's functions
are enabled.
5-16
Chapter 5 Connections and Preparations
To release the key lock completely (Levels 1
to 3)
Enter the password of Level 3 and press the SET key.
The LOCK lamp goes dark, and all the recorder's
functions are enabled.
To activate the key lock again
When you press the LOCK key after releasing the key
lock of any level, the LOCK lamp lights and the
recorder enters lock status again,
Setting the Pre-Reverse Time
(HSR-2/2P only)
With the HSR-2/2P, set the pre-reverse time to see the
latest recorded scenes while recording using the
Playback During Recording function.
When you press the PLAY (PRE REVERSE PLAY)
key during recording, the point of the preset time
before the current time is located on the hard disk, then
playback starts from that point.
The default pre-reverse time is 5 minutes. You may
set it in a range from 1 to 99 minutes in units of
minute.
Set the pre-reverse time at PRE REV TIME in the
Function Control menu.
1
Highlight FUNCTION CONTROL MENU (or
display FuncMenu) of the top menu by pressing
the V or v key, then press the b key.
The Function Control menu is displayed.
SETUP MENU
FUNCTION CONTROL MENU
AUTO REW : ON
POWER ON REC : OFF
BEEP : ON
STILL : FRAME
PRIORITY : PLAY
PRE REV TIME : 5 MIN
FUNCTION LEVEL SET
PASSWORD SET
2
Highlight PRE REV TIME by pressing the v key,
then press the b key.
The setting display for the pre-reverse time
appears.
PRE REVERSE TIME SET
PRE REVERSE TIME : 5MIN
ABORT : MENU KEY
DATA SET : SET KEY
3
Set the pre-reverse time by pressing the V or v key.
4
Press the SET key to register your setting.
A message "NOW SAVING" is displayed, and the
new setting is stored in nonvolatile memory.
To restore the previous setting
Before pressing the SET key, press the MENU key.
A message "ABORT!" is displayed, and the previous
setting is restored.
5-17
Chapter 5 Connections and Preparations