Safety Interlock Harness Installation - Cub Cadet 59A30033150 Operator's Manual

2-8 Safety Interlock Harness
Installation
Remove the panel shown in Figure 2-8a in order to gain
access to the mower's safety interlock switch.
Figure 2-8a
Now, locate the collection system's safety interlock
harness P#(P0208) located on the PTO assembly,
Figure 2-8b. This harness will need to be connected to
the mower safety interlock switch, and then secured to
the mower frame with the zip ties P#(J0245) included in
the mount kit hardware bag. See page 36 for the safety
interlock wiring harness schematic diagram.
Figure 2-8b
Collection
System's
Safety Interlock
Harness
Lift the mower's operator seat. Clip the zip tie on the
collection system's wiring harness and route the harness
up and over the PTO assembly to the first zip tie
connection, near the R.O.P.S. shown in Figure 2-8c.
Figure 2-8c
First Zip Tie
Connection
Route Harness
Up And Out Of
PTO Assembly
Remove Panel
11
Route the remaining safety interlock wiring harness as
shown in Figure 2-8d. Use zip ties where indicated.
Figure 2-8d
Route Under
Seat
Disconnect the mower's safety interlock switch (See
mower's Owner's Manual for location). Plug the male
end of the collection system's wiring harness into the
port where the mower's safety interlock switch was
removed. Then, plug the mower's safety interlock switch
into the female end of the collection system's wiring
harness. Refer to Figure 2-8e & 2-8f (Larger Connection
View). Zip tie the wiring harness to the mower in such a
way that the wiring harness is clear from any moving
parts, or heat sources. Replace the panel and hardware
shown in Figure 2-8a.
Figure 2-8e
Mower's Safety
Interlock Switch
Figure 2-8f
Zip Tie
Here
Collection
System's
Wiring
Harness
Female
Connection
Collection System's
Wiring Harness
Male Connection