Pto Assembly Installation - Cub Cadet 59A30033150 Operator's Manual

2-4 PTO Assembly Installation

Insert the PTO assembly P#(A1821) into the slots on the
PTO mount plate assembly. Secure the PTO assembly
with (1) mount pin P#(B0274) and (1) hair pin clip
P#(K0086).
Remove the belt guard P#(B0679) and hardware in
preparation for the belt installation. Refer to Figure 2-4a.
Figure 2-4a
Hair Pin
Clip
PTO
Mount Pin
PTO Assembly
Belt Guard
Attach the PTO handle P#(A1142) to the PTO assembly
using (3) 1/4"-20 x 3/4" HHCS P#(K1222) and (3) 1/4"-
20 nylon flange locknuts P#(K2014). Attach the handle
grip P#(J0522) to the PTO handle. Refer to Figure 2-4b.
NOTE: The PTO Handle can be adjusted after
performing Step 2-6 to achieve proper belt adjustment.
To adjust the handle, remove (3) 1/4"-20 x 3/4" HHCS
P#(K1222) and (3) 1/4"-20 nylon flange locknuts
P#(K2014), rotate handle until positioned in the desired
location (while aligning holes) and reattach. The bolts
should be kept approximately 120 degrees apart to
ensure proper fastening.
Figure 2-4b
(3) 1/4"-20 x 3/4" HHCS
(3) 1/4"-20 Nylon
Flange Locknut
Handle Grip
PTO Handle
8