Cub Cadet 59A30033150 Operator's Manual page 25

2-13 Boot To Mower Deck Installation
Continued
Step 17: While still holding the boot snug to the mower
deck, tighten the lower set of hardware on the discharge
chute stiffener. You can access this hardware through
the boot opening shown in Figure 2-13s.
Figure 2-13s
Step 2-18: While holding the boot snug to the mower
deck, lift the discharge chute. Tighten the two 3/8"-16
nylon flange lock nuts on the boot plate as shown in
Figure 2-13t.
Figure 2-13t
Lift Discharge
Tighten Lower
Hardware
Chute
Hold The Boot Snug
To The Mower Deck
Hold Boot
In Position
Figure 2-13t
Tighten
Hardware
25