Safety Interlock Harness Installation - Cub Cadet 59A30045150 Operator's Manual

2-20 Safety Interlock Harness Installation

Collection System May Require Dealer Installation!
Before installing, please verify the presence of an auxiliary
5-way male connector in the mower's electrical harness.
The connector is located underneath the operator's seat,
in front of the battery. For early production LZ Models
without the connector, a dealer must perform the complete
collection system installation. If the connector is present,
or an early production SZ Model, dealer installation of the
collection system is not required.
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Dealer Installation
Early Production LZ Models;
Without auxiliary 5-way male connector.
—
Interconnects between right steering lever plunger
—
switch & mower's harness, located underneath
operator's seat. See Figure 2-20a.
Dealer must disassemble the left & right pods along
—
with the seat box to make the electrical connection.
End-User Installation
Early Production SZ Models;
Without auxiliary 5-way male connector.
—
Interconnects between plunger switch & mower's
—
harness, located underneath front left corner of floor
panel, near the brake. See Figure 2-20b.
Connection point requires additional harness length to
—
make connection. Please disconnect standard harness
P#(P0209) from Left PTO Mount Assembly
P#(A1991) and attach Harness Extension
P#(P0263) in-between. See Figure 2-20c.
Current Production LZ & SZ Models;
Auxiliary 5-way male connector present
—
Connects to mower's harness, located underneath
—
operator's seat, in front of battery. See Figure 2-20a &
2-20b.
Harness Routing & Connecting;
First, route the Safety Interlock Harness (w/ Extension,
—
if applicable) along the mower to the connection point.
See Figure 2-20c. When choosing a path for the
harness, make sure it will not contact moving parts or
high heat components. Next, remove any slack from
the harness, loop and fasten the excess using (1) zip-
tie P#(J0245). Then, secure the harness to the mower
frame with the remaining (6) zip ties. Last, check
harness operation only after complete collection
system is installed. With the mower running, deck PTO
off, and not sitting in the operator's seat, engage the
PTO. If correctly installed, the mower should turn off. If
the mower does not turn off, check the steps above
and each connection point.
LZ Model
Figure 2-20a
SZ Model
Figure 2-20b
Figure 2-20c
Interlock
Harness
Connects To
Mower's Plunger Switch
16
Current Production
Connection Point
Early Production
Model -
Interconnection Point
Current Production
Connection Point
Early Production
Model -
Interconnection Point
P0263 - Harness
Extension (Only
P0208 -
Used On Early
Production SZ
P0209 -
Plunger Switch
Connects/Interconnects
To Mower's Harness
Model -
Model -
Models)