Toshiba E-STUDIO45 Operator's Manual page 105

6. OUTPUTTING LISTS & REPORTS (Cont.)
Manually Outputting Lists and Reports (Cont.)
Setting the Number of Communications Output on Transmission/Reception Journal
1
The number of communications on the transmission/reception
journal manually output can be selected from 40 and 120.
2
1 Press the SETTINGS key to display the settings
menu, then the PRINTER key.
3
2 Press the
4
3 Select the number of communications output on the
5
transmission journal and the reception journal re-
spectively, then press the
6
7
8
If an error occurs during communications, an error code is indi-
cated in the Transmission journal or Reception journal.
Refer to the following table for the remedy.
9
Error Code Description
12 Original jam
13 Door open
20 Power interruption
10
30 Reset
33 Polling Error
42 Memory full
11
50 Line busy
Security Mismatch in
53, B1 Relay or Mail
Box transmission
12
B0
Communications error
E8
5-32
ENTERING AND SETTING ITEMS
NEXT key.
SET
Error Code Table
key.
Remedy
Clear the jammed original.
Firmly close the open door.
Check the power interruption report.
Check polling options setup (Security Code, etc.), and
check if the polling document exists.
Make sure that there is sufficient memory before
making the call again.
Retry communications.
Confirm the remote party's Security Code, system
passward, and your setup.
Retry communications.