Fuel System; Steering System - Monterey 180 FS Owner's Manual

Holding Tank
If your boat has an optional waste holding tank installed,
various chemicals are available to control odors and
help break down solids. Consult your marine dealer as
to what to use. After the holding tank is emptied, fill tank
with fresh water and pump it out again to rinse.
Overboard discharge of waste should only be used in
approved areas.
There are many marinas that are certified to pump out your holding tank.
Stainless Steel and Chrome
Stainless steel and chrome plated parts are not totally resistant to
corrosion. Occasional cleaning and polishing with a marine chrome and
stainless polish will maintain and extend the useful life. In salt water areas,
rinse all hardware with fresh water and apply a light coating of corrosion
inhibitor oil to enhance appearance.

FUEL SYSTEM

Fuel lines, vent hoses, and drain hoses should be checked frequently for
leaks. Some models are equipped with removable inspection plates for fuel
system component inspection. If a leak occurs around the fitting, then
tightening of the hose clamps may be all that is necessary. However, if the
leak continues, replace the hose immediately to prevent a build-up of fluids
or gases. Surface cracking on the hose indicates wear, and replacement is
recommended. Use fuel system parts certified for marine use only; do not
substitute automotive parts in marine application.

STEERING SYSTEM

The steering system is the primary link for engine control and must be
inspected and maintained regularly. The hardware at both the helm and
engine end of the steering cable must be checked frequently for tightness.
Refer to the engine operator's manual for the appropriate torques.
The steering bar must be lubricated monthly to ensure smooth operation.
Turn the steering wheel to a full starboard turn to expose the bar. Use a
high quality waterproof marine grease and fully coat the bar. Turn the
steering wheel back and forth to work the grease in.
Care and Maintenance
NOTICE
KC-4055
7-7