Monterey 180 FS Owner's Manual page 12

to keep your boat clean on the road. Your Monterey Dealer will assist you
in finding a suitable cover (not available from Monterey Boats).
Roll clear plastic (isinglass) curtains (do not fold) and store in a clean,
dry place.
Do not allow petroleum products or bug sprays to come in contact with
canvas.
Your Monterey boat is basically an open vehicle. Therefore, in
spite of well-designed and well-fitting canvas enclosures, your
boat is not waterproof. We have made every effort to design
these enclosures to conform with the boat, but a certain amount
of leakage may occur, especially at the seam lines. After cleaning
with soap and water, allow seams to thoroughly dry. A sealant
can be applied on the seams to somewhat close the needle holes
according to the manufacturer's instructions.
Acrylic and Plexiglass
Acrylics and plexiglass have properties that make them ideal for the marine
environment. Components such as cabin doors and deck hatches need
special care to prevent scratches and other damage. The following guidelines
will help keep acrylics and plexiglass looking good for years to come.
DO'S
Wash your hatches, windshield connector, side curtains and other clear
plastic pieces, as well as other acrylic components on your boat with a
mild soap and plenty of lukewarm water.
Use a clean, soft cloth, applying only light pressure.
Rinse with clear water and dry by blotting with a damp cloth or chamois.
Grease, oil or tar may be removed with a good grade of hexane, aliphatic
naphtha or kerosene. These solvents may be obtained at a paint or
hardware store and should be used in accordance with the
manufacturer's recommendations.
To maintain a high-luster finish on your acrylics, we recommend that after
properly cleaning, apply Meguiar's™ Mirror Glaze #10 with a soft towel.
Note: If slight scratches appear on acrylics, use Meguiar's™ Mirror Glaze
#17.
Clear plastic (isinglass) is subject to ultraviolet (sunlight)
degradation over time. It may turn yellow-brown (a burnt
appearance) and get brittle. Two things that can accelerate this
degradation are:
1. Direct contact with aluminum or stainless steel frames. Use
"Standoffs."
NOTICE
NOTICE
M-5