Table of Contents
Advertisement
If Webthru is connected with Internet
dedicated line, cable modem line or on
LAN environment, you should select
network interface as 'Ethernet'.
If Webthru is connected on xDSL line that needs PPPoE process to connect on Internet, administrator should
select 'xDSL (PPPoE)'.
(3) Ethernet Interface
Administrator may configure IP
address, subnet mask, broadcast
address, gateway address, and DNS
addresses of Webthru. For broadcast
address, administrator may set it
automatically by clicking 'Get From
Netmask' button after assigning IP
address and subnet mask.
This interface is mainly used for
Internet dedicated line and LAN, and sometimes for xDSL line as it is explained on 'DHCP Client Protocol'
setting.
MTU Size: Depending on network type, administrator may set data packet size with this menu to utilize the
network at most effectively.
DNS Server IP Address: This is used when you register your Webthru on dynamic IP registration list of
SWR (Webthru Registration Server). SWR has its domain name of 'Webthru.to' and the domain name is
registered on DNS servers on the world.
(4) xDSL Interface
If Webthru is connected on xDSL
line and needs PPPoE process,
administrator should select network
interface as 'xDSL (PPPoE)'. And
administrator should configure user ID and password for PPPoE. ID and password may be acquired from the
ISP that installed the line.
4) Dynamic IP registration service for ISDN and xDSL users
This page is to register Webthru
on dynamic IP registration server.
If Webthru is installed on a
network of dynamic IP address
(floating
IP
address),
administrator should register the
Webthru
on
dynamic
IP
registration
server
to
give
common users simple connectivity. If not, no one can access the Webthru through Web browser. It is because
that no one knows IP address which one can access the Webthru with.
21
Webthru SWC 306 User's Guide
Advertisement
Table of Contents
