Remote Sensor Installation; Remote Sensor Types; T-32-Rs2 Indoor Sensor Installation - Jackson Systems T-32-TS Installation Manual

Hide thumbs Also See for T-32-TS:

Table of Contents

REMOTE SENSOR INSTALLATION

The T-32-TS can accommodate both an indoor and outdoor remote sensor. For

indoor applications, the T-32-RS2 remote sensor can be wired to the thermostat

and

terminals. Each sensor contains two thermistors wired in series with a

switch to select one or both sensors. This reduces the total number of sensors

required for series/parallel temperature averaging. Whenever an indoor remote

sensor is used, the thermostats internal sensor is automatically disabled.

The T-32-OTS outdoor remote sensor is wired to the

and

terminals. The

outdoor sensor thermistor is housed in a waterproof encapsulation and is ideally

suited for ambient conditions ranging from -40 to 140°F and humidity levels of 5

to 95% RH (non-condensing).

Locate the sensor in the same manner as the thermostat. Mount the sensor 18"

away from any outside wall. Do not install the sensor behind doors, in corners or

other dead air spaces. Keep the sensor away from direct air flow, supply

registers or near sources of heat such as lamps and appliances. The maximum

wire length from the sensor to the thermostat is 300'.

Table of Contents

Show Quick Links

Table of Contents