Conventional Heat Pump - Jackson Systems T-32-TS Installation Manual

TESTING
Note: On a call for cooling, the thermostat activates a 3 minute time delay before
the cooling relay 'Y1' is energized.
time delay. After the time delay, the internal fan 'G' and cooling relay 'Y1' will
energize. The word Cool
stage cooling, lower the setpoint below the second stage differential and Cool 2
will flash indicating the 'Y2' cooling relay is energized. Touch
OFF is displayed.

CONVENTIONAL HEAT PUMP

When the T-32-TS is configured for conventional heat pump operation, testing is
the same as a heating and cooling system with the exception that a 3 minute
time delay is activated before the 'Y1' compressor relay will energize on a call for
heating or cooling. Mode
Depending on the mode of operation and equipment configuration,
will flash when the 'Y1' compressor relay is energized.
when the 'Y2' compressor relay is energized.
auxiliary 'W1' relay is energized.
emergency heat. After testing, touch
Mode will flash to indicate the thermostat is in
will flash. If the thermostat has been configured for two
will flash to indicate the thermostat is in time delay.
Heat 2 3
E.Heat will flash when the mode is set to
Mode until the word
44
Mode until the word
Heat or Cool
Heat 2 or Cool 2 will flash
will flash when the
OFF is displayed.