Mitsubishi i-MiEV 2017 Owner's Manual page 170

NOTE
 If you enter the wrong number, the voice
guide will say "Pairing failed" and the pair-
ing process will be cancelled.
Confirm the number is right, and try pairing
it again.
8. The voice guide will say "Please say the
name of the device after the beep." You
can assign a desired name for the Blue-
®
tooth device and register it as a device
tag. Say the name you want to register
after the beep.
NOTE
 When the confirmation function is on, after
repeating the device tag you have said, the
voice guide will ask "Is this correct?"
Answer "Yes."
To change the device tag, answer "No" and
then say the device tag again.
9. The voice guide will say "Pairing com-
plete," and the pairing process will end.
 Pairing procedure - Type 2
equipped)
1. Stop your vehicle in a safe area, put the
selector lever in the "P" (PARK) position,
and then pull the parking brake lever.
NOTE
 You cannot pair any Bluetooth
®
the Bluetooth 2.0 interface unless the vehi-
cle is parked. Before paring a Bluetooth
device with the Bluetooth
confirm that the vehicle is parked in a safe
location.
2. Press the PICK-UP button.
3. Say "Pair Device."
NOTE
 The following procedure (
be used instead of saying "Pair Device."
Replace this step 3 with the following proce-
dure if you prefer.
Say "Setup."
Say "Pairing Options."
The voice guide will say "Select one of
the following: pair, edit, delete, list or set
code."
Say "Pair."
 If 7 devices have already been paired, the
voice guide will say "Maximum devices
paired" and then the system will end the
(if so
pairing process. To register a new device,
delete one device and then repeat the pairing
process.
(Refer to "Deleting a device" on page 5-62.)
Bluetooth® 2.0 interface (if so equipped)
4. The voice guide will say "Start pairing
procedure on the device. See the device
®
device with
manual for instructions." and then will
say "The pairing code is <pairing code>."
®
NOTE
®
2.0 interface,
 Some Bluetooth
pairing code. Please refer to the device man-
ual for pairing code requirements and read
the next section "If your device requires a
specific pairing code" on page 5-62 to set the
pairing code.
 The pairing code entered here is only used
for the Bluetooth
to ) can also
Depending on the connection settings of the
®
Bluetooth
entered each time you connect the Blue-
®
tooth device to the Bluetooth
face. For the default connection settings,
refer to the instructions for the device.
5. Enter in the Bluetooth
number that has been read out in Step 4.
NOTE
 Depending on the device, it might take a few
minute to pair the Bluetooth
the Bluetooth
Features and controls
®
devices require a specific
®
connection certification.
device, this code may have to be
®
2.0 inter-
®
device the 4-digit
®
device with
®
2.0 interface.
5-61
5