Mitsubishi i-MiEV 2017 Owner's Manual page 68

Phenomena
The following Blinks after about 1 sec-
symbol blinks ond.
when the power
supply/communi-
cation switch on
the MiEV Remote
is pressed.
Blinks after about 10
 ERROR sym-
seconds.
bol
 symbol
The below symbol blinks about 10 seconds
after the power/communication switch on the
MiEV Remote is pressed.
 ERROR symbol
Cause
 Electrical noise source is present in the
vicinity of the MiEV Remote. (e.g.
personal computer)
 Electrical noise source is present
between the vehicle and the MiEV
Remote.
The MiEV Remote antenna is not
extended.
Out of effective communication range.
(e.g. too far away from the vehicle, or
radio signal is interfered)
The electric motor switch is at the position
other than "LOCK" position.
 Electrical noise source is present in the
vicinity of the vehicle.
 Electrical noise source is present
between the vehicle and the MiEV
Remote.
12V starter battery is discharged.
Some errors occur while the system is in
processing.
MiEV Remote System
Remedy
Move away from the noise source.
Extend the MiEV Remote antenna to communicate.
Move to the location where the system reaches the
effective communication range.
Turn the electric motor switch to the "LOCK" posi-
tion.
Move away from the noise source.
Charge or replace the 12V starter battery.
Refer to "Jump-starting" on page 8-2, "12V starter
battery" on page 11-6.
Press the power/communication switch again.
General information/Charging
3
3-53