Mitsubishi i-MiEV 2017 Owner's Manual page 169

Bluetooth® 2.0 interface (if so equipped)
You can also change a Bluetooth
be connected.
To pair
®
To pair a Bluetooth device with the Blue-
®
5
tooth 2.0 interface, use either one of the fol-
lowing 2 methods (Type 1 or Type 2).
 Pairing procedure - Type 1
equipped)
1. Stop your vehicle in a safe area, put the
selector lever in the "P" (PARK) position,
and then pull the parking brake lever.
NOTE
 You cannot pair any Bluetooth
®
the Bluetooth 2.0 interface unless the vehi-
cle is parked. Before paring a Bluetooth
device with the Bluetooth
confirm that the vehicle is parked in a safe
location.
2. Press the PICK-UP button.
3. Say "Setup."
4. Say "Pairing Options."
5. The voice guide will say "Select one of
the following: pair, edit, delete, or list."
Say "Pair."
5-60 Features and controls
®
device to
NOTE
 If 7 devices have already been paired, the
voice guide will say "Maximum devices
paired" and then the system will end the
pairing process. To register a new device,
delete one device and then repeat the pairing
process.
(Refer to "Deleting a device" on page 5-62.)
6. The voice guide will say "Please say a 4-
digit pairing code." Say a 4-digit number.
(if so
When the confirmation function is on, the
system will confirm whether the number
said is acceptable. Answer "Yes."
Answer "No" to return to pairing code
selection.
NOTE
®
 Some Bluetooth
device with
pairing code. Please refer to the device man-
ual for pairing code requirements.
®
®
2.0 interface,
 The pairing code entered here is only used
7. The voice guide will say "Start pairing
®
devices require a specific
 Depending on the device, it might take a few
 If the Bluetooth
NOTE
®
for the Bluetooth connection certification.
It is any 4-digit number the user would like
to select.
Remember the pairing code as it needs to be
®
keyed into the Bluetooth device later in the
pairing process.
Depending on the connection settings of the
®
Bluetooth device, this code may have to be
entered each time you connect the Blue-
® ®
tooth device to the Bluetooth 2.0 inter-
face. For the default connection settings,
refer to the instructions for the device.
procedure on the device. See the device
manual for instructions." Enter in the
®
Bluetooth device the 4-digit number you
have registered in Step 6.
NOTE
®
minute to pair the Bluetooth device with
®
the Bluetooth 2.0 interface.
®
2.0 interface cannot recog-
®
nize the Bluetooth device, the voice guide
will say "Pairing has timed out" and the pair-
ing process will be cancelled.
Confirm that the device you are pairing sup-
®
ports Bluetooth , and try pairing it again.